1) The filter plate assembly of the operator should stand in the filter discharge side of the blade, use the jog operation mode to adjust the filter to a piece of the rotor plate is about to reach the scraper filter range, the scraper blade screw loosening and the scraper is temporarily missing.
2) Install the replacement filter plates, should carefully remove the rotor flange filter assembly of slag surface and the mounting holes to avoid when wearing mineral powder caught in the bolt circle of the base level and flange assembly intermediate, resulting in not allowed, while clean filter plate assembly of ring plane.
3) Insert the filter plates filter water Tsui flexible joint, the first tie him one of them bolts, but do not tighten until the tie him another bolt, it does not tighten, then install the correct disc filter plates indexing position, and the upper and lower corners, until a little more straightened again when the bolts to prevent the up and down, temporarily turn the filter rotor, then This is the way to install a second filter plate, and adjust the filter plate are two splicing curvature of space and form, will not peak until satisfied and then torque wrench to tighten the strength of 3Kg ~ 4Kg bolt the two plates. Each plate when tightening the two bolts should be tightened alternately synchronized, and then tighten the flexible connector hose clamps. The filter plates are installed two plates full circle forming the roundness of the stitching and stitching the basis of the size of space, and then the rotor to move the filter slightly to make the first piece of filter plate into the blade area, adjusting the blade films, temporarily away from the plate scraper spacing of about lmm, but the blade does not tighten until the filter plates be fitted complete circle, and then one by one with each plate measuring blade pitch for the next record. Then the blade and the board raised the minimum distance 0.5mm, and tighten the screw blade, the ring plate is installed. Each filter plate is installed with the serial number should be registered, so you can replace the reference.
4) the installation of filter plates each circle should follow the above steps. For installation of damping cushion film filters and filter board (such as import filter) can still use the original gasket, the assembly to get the same elevation. But the company's filter plate assembly of rings using polymer materials, has a seismic crack, but also to directly meet with the filter flange. Other side of the non-benchmark cover the mounting holes should be coupled with a spring cushion pad, plus screws and tighten. The filter plate assembly of the company has reached to install precision flatness, no local pad used to solve the flatness of Cyprus.